Sika® Shot-60

6 months from date of production If stored properly in undamaged, original,sealed packaging.

Store in dry and cool conditions, protected from direct sunlight.

Approx. 1.9 kg/L (at 25°C)

Grain size 0 - 3.35mm

~ 2.0 N/mm²  (After 28 days)

Bond strength on concrete (blastcleaned)

60 - 90 seconds (at 25°C/65% r.h.)

Water : Powder = approx. 12% part by weight

90 - 150 seconds (at 25°C/65% r.h.)

Water : Powder = approx. 12% part by weight

The rate of coverage depends on the surface texture of the substrate, the location of the area to be sprayed (overhead or vertical) and the thickness of the applied coating. As a general guide, allow 25 – 30 kg/m² per 10 mm applied thickness.

Sika® Shot-60 may be applied using any type of small dry-spray cement gun (rotor capacity up to 2.0 litres approx.). When the substrate has been suitably prepared, wet down thoroughly (this is normally best done using the spray nozzle).
Sika® Shot-60 is placed directly into the hopper of the spraying machine; the required water is then added at the nozzle simultaneous to spraying onto highly dampened rock, concrete or masonry.

Recommended equipment:

Uncured mortar should be removed from tools with water. To clean dry-spray cement guns simply blow out with compressed air. Once cured, the mortar can only be removed mechanically.