Product Data Sheet
Show all documents

Sikafloor®-94

Low viscosity, slovent free epoxy Primer and general Binder resin

Sikafloor®-94 is a 2 componant epoxy - low viscosity Primer for Sikafloor systems and a Binder resin for General mortars

  • Low viscosity
  • Excellent substrate penetration
  • Very low odour - VOC
  • Excellent binder for mortars
  • Fast to cure
  • Can be accelerated with Sikafloor Booster
  • Economical
Product Data Sheet
Show all documents

Usage

  • Primer for concrete surfaces with Sikafloor resin systems.
  • Binder resin for Epoxy mortar Sub-fill mortar screeds.
  • Binder for epoxy Coving mixes.
  • Flow and scratch coat layering prior to Sikafloor systems.
 

Advantages

  • Low viscosity
  • Excellent substrate penetration
  • Very low odour - VOC
  • Excellent binder for mortars
  • Fast to cure
  • Can be accelerated with Sikafloor Booster
  • Economical

Packaging

15 kg set Parts A+B

Colour

Yellowish transparent

Product Details

Product Information

Shelf life

Stored in original sealed containers within the temperature range of +5 to +35 degress C, this product will keep for a minimum of 3 years

Storage conditions

Stored in a dry place and out of direct sunlight within temperatures as mentioned above.

Density

1.1kg / litre
Technical Information

Compressive Strength

> 40 MPa

Tensile Strength in Flexure

22 MPa

Tensile Adhesion Strength

12 MPa approx - (to sandblasted steel)

Application

Application Information

Mixing Ratio

Part A   Part B  = 2 :1  (by Mass and Volume)

 

Ambient Air Temperature

Application range recommended  +5 to +30 Degrees C

Pot Life

10 Degrees C  - 30 mins.

20 Degrees C  - 20 mins.

Waiting Time / Overcoating

10 degrees C  15 hours

20 degrees C    8 hours

Note;  Waiting time are approx. halved with the addition of Sikafloor Booster
Consumption

Consumption

Primer

CSP 2-3 profile  2-3 m2 L approx.

CSP 4-5 profile  5-6 m2 L approx.

Mortar

Range of 5:1- 8:1 - mixed litre to kg blended silica sands
Application steps

MIXING

Part A and B to be mixed the correct ratio for a minimum of 2 minutes

APPLICATION

Primer

Roll product evenly on and into the surface.

If the product is completely absorbed then an additional coat should be applied within 24 hours.

Mortar

When used as a binder in Profiling sreeds or Coving mixes, the substrate should also be primed with Sikafloor®-94

Documents