Sarnacol®-808 TH

A chloroprene rubber

12 months from date of production.

Stored properly in undamaged, and unopened original sealed packaging in dry and cool conditions. Keep away from the sunlight.

20-27%

3,700-4,300  CPS/30°C

Above 5°C

Concrete, screed, some metal sheet type, plywood panels, fibre cement boards.

0.4 - 0.6 kg/m²  depend on the roughness and absorbency of the substrate.

The substrate must be sufficient strength and adhesion to resist the forces generated by wind suction.

The substrate must be firm, clean, free of stripping agents, dry and standing wate must be dried off.

• Apply scratch coat adhesive by using trowel, the consumption around 0.1 kg/m². Then wait around 30-60 minutes until the adhesive forms a skin.
• Position and straighten Sarnafil® membrane.
• Apply the adhesive, the consumption around 0.3 - 0.5 kg/m² depend on the roughness and absorbency of the substrate.Preferably using a roller (make sure there are no lumps)
• Do not apply the adhesive to an area greater than can be covered in 15 minutes.

Tool and equipment must be cleaned with solvent. Once hardened, the adhesive can only be removed mechanically.