Davco ULTRAFLEX

Hydraulic binder, mineral filler and admixtures

12 months from date of production if stored in undamaged and unopened, original sealed packaging.

Store in dry condition and protected from direct sunshine.

1.3 ± 0.1 kg/L

12 ± 1

< 0.5 mm

Approx. 4.8 to 5.2 litre water per bag 20 kg

Approx. 6 to 6.5 litre water per bag 25 kg

+5°C to +35°C

180 - 240 minutes (at 25°C)

20 - 25 minutes (at 25°C)

15 - 20 minutes (at 25°C)

~ 24 hours

<sup><sub>Note:
1. This is an average calculation. Actual usage may differ from estimate. Due to the different surface conditions. Surface absorption and the purpose of the individual's use.
2. For tile size more than 40 cm x 40 cm should apply tile adhesive on surface and very thin layer on a back of tile.</sub></sup>

• Mix Davco ULTRAFLEX
  - 20 kg with 4.8 - 5.2 Litres of clean water
  - 25 kg with 6 - 6.5 Litres of clean water
  by electrical mixer until the compound is evenly distributed.
• Allow the mixture to stand for 2 - 3 minutes for good reaction and reducing air bubble before using the adhesive.

• Spread tile adhesive by using notched trowel onto substrate.
• Fix tile on tile adhesive and knocked over with rubber hammer
• The dual bonding will be applied when size of tile is over than 25 cm x 25 cm. Applying thin layer of tile adhesive onto a back of tile, then fix the tile on tile adhesive substrate.