Product Data Sheet Safety Data Sheet Show all documents

Davco® AC-2

CEMENT BASED TILE ADHESIVE

Davco® AC-2 is a general cement based tile adhesive for ceramic tile.

  • Good bonding strength
  • Suitable for fixing ceramic tile up to 30 x 30 cm.
  • Tile on wall and floor
  • Good value tile adhesive to replace traditional mortar
Where to buy Consumption Calculator
Product Data Sheet Safety Data Sheet Show all documents

Usage

  • Exterior and Interior Floor
  • Interior wall
  • Substrates: Cement
 

Advantages

  • Good bonding strength
  • Suitable for fixing ceramic tile up to 30 x 30 cm.
  • Tile on wall and floor
  • Good value tile adhesive to replace traditional mortar

Packaging

20 kg/ bag

Colour

Grey powder

Product Details

Product Information

Composition

Hydraulic binder, mineral filler and admixtures

Shelf life

12 months from date of production if stored in undamaged and unopened, original sealed packaging.

Storage conditions

Store in dry condition and protected from direct sunshine.

Density

1.2 ± 0.1 kg/L

pH-Value

12 ± 1
Technical Information

Tensile adhesion strength

Initial  ≥ 0.5 MPa

Application

Application Information

Mixing ratio

Approx. 4.5 to 5 litre water per bag 20 kg

Ambient air temperature

+5°C to +35°C

Pot Life

180 - 240 minutes (at 25°C)

Open Time

10 - 15 minutes (at 25°C)

Adjustability time

10 - 15 minutes (at 25°C)

Applied product ready for use

~ 24 hours
Consumption

Consumption

Trowel size

Size of tile
(cm x cm)

Surface of tile

(cm2)

Consumption

(20 kg)

3 mm

2.5 x 2.5

5.0 x 5.0

6.25

25

7 - 8 m2

6 mm

10 x 10

20 x 20

20 x 25

30 x 30

100

400

500

900

5 - 6 m2

Note:
1. This is an average calculation. Actual usage may differ from estimate. Due to the different surface conditions. Surface absorption and the purpose of the individual's use.
2. For tile size more than 40 cm x 40 cm should apply tile adhesive on surface and very thin layer on a back of tile.
 
Application steps

MIXING

  • Mix Davco® AC-2 20 kg with 4.5 - 5 Litres of clean water by electrical mixer until the compound is evenly distributed.
  • Allow the mixture to stand for 2 - 3 minutes for good reaction and reducing air bubble before using the adhesive.

APPLICATION

  • Spread tile adhesive by using notched trowel onto substrate.
  • Fix tile on tile adhesive and knocked over with rubber hammer.
  • The dual bonding will be applied when size of tile is over than 25 cm x 25 cm. Applying thin layer of tile adhesive onto a back of tile, then fix the tile on tile adhesive substrate.
 

Documents