LANKO® 227 Flex Shield

Hydraulic cement, mineral filler, admixtures and special polymer

12 months from the date of production If stored properly in undamaged and unopened, original sealed packaging.

Store in dry condition and protected from direct sunshine.

Fresh mortar density 1.6- 1.7 kg/L

Dry density  0.9-1.1 kg/L

0.04 - 0.5 mm

≥ 1 MPa at 28 days (Bond to concrete)

No water penetration (at 1.5 bar water pressure)

+10°C to +35°C

~ 40 minutes (at 25°C)

3 - 4 kg/m² for 2 coats at 2 mm thickness

Mix 20 kg of LANKO® 227 Flex Shield with 5.8 - 6.2 litres of clean water (29% - 31% by weight) with electric drill until the product is evenly distributed and homogenous paste.
Leave to stand for 2 minutes.

1. LANKO 227 FLEX SHIELD can be applied by brysg and trowel
2. Apply the 1^st coat with consumption 1.5 to 2 kg/m²
3. The 2^nd coat can be applied after dying preriod of 2 to 6 hours (Temperature depend) with consumption 1.5 kg to 2 kg/m²
4. Apply a minimum of two cross coats
5. Clean tools with water immediately after use

REINFORCEMENT

• For substrates subject to micro-cracking, the 1st coat should be reinforced with LANKO GLASS FIBER MESH.

SUITABLE COVERING MATERIALS

• LANKO® 227 Flex Shield can be covered with tiles within a period of 3 days minimum to 7 days maximum after application of the final coat (bonded with tile adhesive, DAVCO SUPER TTB or DAVCO ULTRAFLEX) or a cement mortar screed.
• For special area such as swimming pool, should be used LANKO® 227 Flex Shield bonded with DAVCO ULTRAFLEX or DAVCO POOL TILE ADHESIVE. In addition, for good result should be fill join with DAVCO POOL TILE GROUT or high protection with DAVCO ULTRA EPOXY GROUT.
• High-traffic areas should be protected against abrasion.