Product Data Sheet Safety Data Sheet Show all documents

LANKO 111 BASECOAT

FINE REDERING POWEDER FOR INTERIOR / EXTETIOR WALL AND CEILING

LANKO 111 BASECOAT is a cement mortar for small thickness finished between 1 mm and 4 mm. A plane, regular surface is obtained, ideal for decorative wall-coverings. Ideal for helping to level of wall surfaces prior to apply LANKO 110 SKIMCOAT.

  • Fine finishing and competible with decorative wall-covering
  • For repairing small defects on concrete or traditional rendering walls and ceiling surfaces
Where to buy
Product Data Sheet Safety Data Sheet Show all documents

Usage

LANKO 111 BASECOAT is suitable for wall and ceiling, interior and exterior application.
  • Reinforced concrete
  • Precast concrete panels
  • Traditional rendering
  • Base coat before apply LANKO 101 PARENDUIT or LANKO 110 SKIMCOAT
 

Advantages

  • Fine finishing and competible with decorative wall-covering
  • For repairing small defects on concrete or traditional rendering walls and ceiling surfaces

Packaging

20 kg/bag

Colour

Grey powder

Product Details

Product Information

Composition

Hydraulic binder, mineral filler, aggregate and admixtures

Shelf life

12 months from date of production if stored in undamaged and unopened, original sealed packaging

Storage conditions

Store in dry condition and protected from direct sunshine

Density

1.1 - 1.3 kg/L

Maximum grain size

0.5 mm

pH-Value

~ 12
Technical Information

Tensile adhesion strength

≥ 0.5 MPa at 28 days

 

Application

Application Information

Mixing ratio

Approx. 5.4 to 5.6 litre water per bag 20 kg

Layer thickness

1 - 4 mm

Ambient air temperature

+5°C to +35°C

Pot Life

Approx. 120 minutes (at 25°C)

Initial set time

Approx. 250 minutes (at 25°C)

Waiting time to overcoating

~ 3 days
Consumption

Consumption

Approx. 1.3 kg/m2 per 1 mm thickness
Application steps

MIXING

  • Mix LANKO 111 BASECOAT 20 kg. bag with 5.4 - 5.6 litre of clean water (27 - 28% of mortar) until the product is evenly distributed.
  • Use mixing machine mix at low speed not over than 500 RPM.
  • Mixing time: at least 3 minutes or required consistency is obtained
  • Leave to stand for 1-3 minutes.
  • Do not add water after mixing.

APPLICATION

  1. Apply the first coat with trowel.
  2. Allow a sufficient drying time for 10 - 45 minutes so that it is not drawn off while applying 2nd coat.

Documents