Product Data Sheet Safety Data Sheet Show all documents

LANKO 113 PATCH

THIN RENDERING MORTAR FOR SMOOTH FINISHING

LANKO 113 PATCH is a one component, ready-mixed powder for leveling and smoothing uneven surface of wall and ceiling.

LANKO 113 PATCH provides similar finishing with normal rendering and compatible with decorative wall-covering.
  • Easy to use and apply, just add water
  • Interior and exterior application
  • Can be exposed or covered by other materials
  • Smooth finished result as normal rendering with grey color
  • Compatible with decorative wall covering
  • Good adhesion
Where to buy
Product Data Sheet Safety Data Sheet Show all documents

Usage

LANKO 113 PATCH is used as an underlay before skim coating on concrete, mortar, brick and block. Lanko 113 PATCH is a cosmetic mortar designed to eliminate surface defects 3-10 mm on
  • Fair-face concrete
  • Precast concrete panels
  • Columns and beams
  • Block works
 

Advantages

LANKO 113 PATCH provides similar finishing with normal rendering and compatible with decorative wall-covering.
  • Easy to use and apply, just add water
  • Interior and exterior application
  • Can be exposed or covered by other materials
  • Smooth finished result as normal rendering with grey color
  • Compatible with decorative wall covering
  • Good adhesion

Packaging

25 kg/bag

Colour

Grey powder

Product Details

Product Information

Composition

Cementitous and polymer modified powder

Shelf life

12 months from date of production if stored in undamaged and unopened, original sealed packaging.

Storage conditions

Store in dry condition and protected from direct sunshine

Density

1.4 - 1.5 kg/L

Maximum grain size

0.5 mm

pH-Value

~ 12
Technical Information

Tensile adhesion strength

> 0.75 MPa at 28 days

Application

Application Information

Mixing ratio

Approx. 5.25 to 5.50 litre water per bag 25 kg

Layer thickness

3 - 10 mm

Ambient air temperature

+5°C to +35°C

Pot Life

Approx. 150 minutes (at 25°C)

Initial set time

Approx. 3 hours (at 25°C)

Waiting time to overcoating

~7 days
Consumption

Consumption

Approx. 1.3 kg/m2 per 1 mm thickness
Application steps

MIXING

  1. Mix LANKO 113 PATCH 25 kg. bag with 5.25–5.50 litre of clean water (21-22% of mortar) until the product is evenly distributed.
  2. Use mixing machine mix at low speed not over than 500 RPM.
  3. Mixing time: at least 3 minutes and required consistency is obtained.
  4. Leave to stand for 1-3 minutes.
  5. Do not add water after mixing.

APPLICATION

  1. Apply the first coat with a trowel.
  2. Allow a sufficient drying time 3-4 hours so that it is not drawn off while applying 2nd coat.
  3. Use a sponge to rub the surface in a circle motion for smooth finishing.
  4. Allow a minimum of 7 days curing before applying a covering material.

Documents