SikaShield® W1
SikaShield® W1 is a 1-part polymer modified cementitious adhesive for bonding the SikaShield® W bituminous membranes on concrete substrates.
- Provides very good adhesion between the bituminous membrane and the concrete surface
- Fast and easy installation
- Very good mechanical strength
- Requires minimum surface preparation
- Can be applied on wet concrete
Usage
The Product is used for:- Basements and other below ground structures
- Horizontal reinforced concrete slabs, decks and podiums
- Vertical reinforced concrete walls
Advantages
- Provides very good adhesion between the bituminous membrane and the concrete surface
- Fast and easy installation
- Very good mechanical strength
- Requires minimum surface preparation
- Can be applied on wet concrete
Packaging
25 kg bag
Refer to the current price list for available packaging variations.
Colour
Red powder or grey powder
Product Details
Composition
Polymer modified cement
Shelf life
6 months from date of production.
Storage conditions
The Product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +25 °C. Always refer to packaging.
Refer to the current Safety Data Sheet for information on safe handling and storage.
Bulk density
Bulk density of powder | 1.50 kg/l |
Application
Fresh mortar density
Density of fresh adhesive | ~1.94 kg/l |
Material temperature
Maximum | +40 °C |
Minimum | +10 °C |
Ambient air temperature
Maximum | +40 °C |
Minimum | +10 °C |
Mixing ratio
~8 - 8.75 litres of clean water per 25 kg bag
Pot Life
~30 minutes (at +27 °C and 65 % r.h)
Consumption
~2.0–3.0 kg/m2
Note: Consumption data is theoretical and does not allow for any additional material due to surface porosity, surface profile, variations in level, wastage or any other variations. Apply product to a test area to calculate the exact consumption for the specific substrate conditions and proposed application equipment.
SUBSTRATE QUALITY
When designing the waterproofing system, make sure that the supporting structure has sufficient structural strength to support all new and existing layers of the system build-up. New concrete substrates must be at least 3 days old.
The substrate must be free of any sharp protrusion or burrs, clean, free of grease, laitance, oil and loosely adhering particles.
MIXING
IMPORTANT!
Over addition of water
Do not add more than prescribed addition of water to the powder. Over addition affects the Product's finished mechanical performance.
- Pour the minimum amount of water into a suitable clean mixing container.
- While mixing gradually add the powder.
- Gradually add the aggregate to the mix.
- Mix continuously for at least 2 minutes to achieve a uniform mix. If necessary, add more water up to the maximum amount to achieve the required consistency.
- Leave to stand for 2 minutes.
- Mix for a further 1 minute.
APPLICATION
- Saturate the substrate with clean water.
- Pour the mixed Product onto the substrate.
- Spread the Product evenly using a smooth trowel or "medium or long" nap paint roller.
- Immediately apply the SikaShield® W bituminous membrane while the adhesive is still wet. Refer to the current Product Data Sheet for further application advice.
CLEANING OF EQUIPMENT
Clean all tools and application equipment with water immediately after use. Hardened material can only be removed mechanically.